Modeling this bear is not easy to me.Especially for its ears i model quite terrilblely.im still not goot at using extrude tools.its also quite hard to model its arms and legs.it is because the legs and arms are irreguler cylinder shapes,sometime i found so hard to model curve part of legs and arms.For side part modeling i think i done quite good,the object can fit the side image plane well.for other sides ,because i neglect that the object should be taken as same size when you create image planes,so my front image is quite large then side image,i can only model proportionally on front side.for modeling bear's body.it has different shape from left side and back side.i was careful to model back side and try not to affect left side shape.
The ribbon modeling should have use more useful maya tool.i just control the face ,vertexs and edges to create the waves of ribbon,i also use same way to model its arm and leg by using move and scale tool bevel the sharp edges,then smooth the whole surface.I think i done not very well because dont have maya in my PC i have to be rush to finish the work,and i also dont konw well about using many model tool currectly,but with more practice,i could have done this better.
From side ,the ears didnt model properly,the ear edges are quite sharp even i use bevel and smooth its surface can not fix it.I may have did wrongly from the very start.And its lower jaw is not sharp enough,once i make the lower jaw sharp and drag it down,then the shape from side is changed.
For the side view ,i think i done quite well.
From the back side,the arms and legs should have made them more curving to the center of body.
top side.




No comments:
Post a Comment